AMT Datasouth Fastmark M6 PLUS Series Guía de usuario descargar pdf (Pagina 9)

3. Setup

3.1 Setting Up the Printer

1. Place the printer on a flat, secure surface.

2. Make sure the power switch is set to “off”.

3. Connect the printer to the computer with the provided USB cable.

4. Plug the power cord into the AC power cord socket at the rear of the printer, and then plug the

power cord into a properly grounded power outlet.

3.2 Media Installation

3.2.1 Loading Internal Media

1. Open the printer top cover by pulling the tabs located on each side towards the front of the

printer, and then lift the top cover to the maximum open angle.

2. Separate the media holders to the label roll width.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Sin comentarios

AMT Datasouth Fastmark M6 PLUS Series Guía de usuario Pagina 9