AMT Datasouth Fastmark M4 Series Guía de usuario descargar pdf (Pagina 32)

~ 32 ~

Dump Mode

The printer will enter dump mode after printing the configuration page. In the

dump mode, all characters will be printed in 2 columns as following. The left side

characters are received from your system and right side data are the

corresponding hexadecimal value of the characters. It allows users or engineers

to verify and debug the program exceptions.

 Dump mode requires 4” wide paper width setting.

 Turn off / on the power or press FEED button to

resume printer for normal printing. (Ready mode)

Printer defaults

Printer configuration will be restored to defaults as below after initialization.

ASCII Data

Hexadecimal Data

Parameter

Default setting

Speed

50.8 mm/sec (2 ips)

Density

Media Width

4” (101.5 mm)

Media Height

4” (101.5 mm)

Sensor Type

Gap sensor

Print Direction

Reference Point

0,0 (upper left corner)

Gap Offset

Post-Print Action

Tear mode

Serial Port Settings

9600 bps, none parity, 8 data bits, 1 stop bit

Code Page

850

Country Code

001

Clear Flash Memory

Media Calibration:

Perform media calibration when completing the Initialization. Turn

ON the printer and open/close the media cover.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 61 62

Sin comentarios

AMT Datasouth Fastmark M4 Series Guía de usuario Pagina 32