AMT Datasouth Accel-7450 Manual de usuario descargar pdf (Pagina 8)

ACCEL-7450

Diagnostic Test Functions

Printer Alignment Functions

SENSOR &

GAP MOTOR

OUTPUT

Power-up while pressing ALT + MENU keys together. LCD will display the

following:

 L.EG ~ left paper edge sensor value (sensor is located on head carrier)

 R.EG ~ right paper edge sensor value (sensor is located on head carrier)

 PS ~ cut-sheet media sensor value (sensor is located above paper tray)

 GAP ~ position (number of steps from HOME to PLATEN)

NOTE: the above values are dynamic and update with changing paper or

printing.

PRINT GAP

TEST

Power-up while pressing EJECT/LOAD + TEAR OFF + LF keys together.

The printer will begin gap testing continuously. Approximately, every 4-

seconds a new Gap operation is performed. The current and historic values

are displayed as follows:

 MIN ~ smallest print gap distance recorded

 MAX ~ largest print gap distance recorded

 CUR ~ most recent print gap distance

 TOTAL ~ number of print gaps performed

 MISS ~ number of times print gap was not within tolerance

USB DATA

LOSS TEST

Power-up normally. Press ONLINE to take the printer offline. Press and hold

the ENTER key for five (5) seconds. The LCD will display the following:

 IN ~ number of bytes received from USB port

 OUT ~ number of bytes retrieved from buffer and currently printed

ASCII

SELF TEST

Power-up while pressing LF key. LCD will display INITIALIZING… CUT

SHEET / ASCII TEST. Press ONLINE and SPEED key to change print

speed. Press ONLINE to resume printing.

HEX DUMP

Power-up while pressing SPEED key. LCD will display INITIALIZING… HEX

DUMP.

CHARACTER

“H” TEST

Power-up while pressing TEAR OFF key. LCD will display INITIALIZING…

CUT SHEET / H PRINT

NEEDLE TEST

Power-up while pressing HIGH IMPACT key. LCD will display

INITIALIZING… CUT SHEET / PIN TEST

HA GAP

ADJUSTMENT

Power-up while pressing LF + RLF keys together. LCD will display the

following:

 HEAD GAP ADJ DW, numeric value (larger number/less gap)

 HEAD GAP ADJ UP, numeric value (larger number/greater gap)

MULTI-PART

GAP ADJUST

Power-up while pressing TEAR OFF + LF + RLF keys together. LCD will

display the following:

 HEAD GAP ADJ MUL, numeric value (larger number/greater gap)

REGISTRATION

ADJUSTMENT

Power-up while pressing ENTER + RLF keys together. LCD will display the

following:

 HORIZONTAL DOT ADJUSTMENT, Mode 0~4.

TEAR OFF

ADJUSTMENT

Press TEAR OFF key 6-seconds. LCD will display the following:

 LF – INC (INCREASE) advances the paper further outside printer

 RLF – DEC (DECREASE) retracts the paper inside printer

 ETNTER – saves setting

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Comentarios a estos manuales

Sin comentarios

AMT Datasouth Accel-7450 Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo AMT Datasouth Accel-7450