AMT Datasouth Fastmark M1 Guía de usuario descargar pdf (Pagina 450)

100

101

Supported Printers and Drivers

Option Description

Cut Options

n Use PSO - Uses the cut option selected in the device Options dialog box. Setting

the cut option in the Label Options dialog box provides label specific cutting

options. Whereas, setting the cut option in the device Options dialog box

produces the same behavior for all labels printed on that specific printer.

n Cutter Off - Disables the cut mechanism on the printer.

n Cut After Every Tag - Cuts before first tag, cuts each tag and cuts after last tag.

n Cut After Every Batch -Cuts before first tag, cuts after batch. Cuts in strips, not

each tag.

n Cut After Last Tag in Batch – Cuts before first tag, cuts each tag, cuts after the last

tag and feeds one or two tags past the printhead when it cuts the last tag in the

last batch.

n Cut Every Tag and After Batch – Does not cut before the first tag in a batch, but

cuts between each tag and after the last tag in the batch. The feed key must be

pressed to feed the last tag out far enough to be cut.

Note: When using the cutter with 98x Printers, please review Loftware Knowledge Base Article #2009218 for

information regarding different behaviors in Modes, Versions, and Cut Intervals.

Backfeed Options

n Use PSO Backfeed - Uses the backfeed option selected in the device Options

dialog box. Selecting a Backfeed Options setting in the Label Options dialog box

applies label specific backfeeding behavior to each label, that is, all labels printed

on that specific printer.

n Disable Backfeed - No backfeed motion occurs.

n Enable Backfeed - Backfeed motion occurs after each printed label. This option

can be used on any printer without a knife.

n Extended Backfeed - An extended backfeed motion occurs after each printed

label. This option is only valid on the 9835 and 9840 printers.

Paxar MPCL2 Printer Specific Options

Printer Specific Options (PSOs) can be accessed by clicking Options while configuring the printer or by

selecting the printer from the Device Configuration grid and clicking Options.

Loftware Label Manager Version 10.1.1 User's Guide

450

1 2 ... 445 446 447 448 449 450 451 452 453 454 455 ... 531 532

Comentarios a estos manuales

Sin comentarios

AMT Datasouth Fastmark M1 Guía de usuario Pagina 450

Comentarios a estos manuales