AMT Datasouth Fastmark M1 Guía de usuario descargar pdf (Pagina 481)

Toshiba TEC Printers

Media Options Section

Stock

Type

n Continuous Stock - Continuous media with no black stripe and no gap.

n Die Cut Stock - The label-to-label gap is automatically sensed by the transmissive sensor and the

paper position is finely adjusted for every piece.

n Mark Stock – The black mark provided on the back side of the stock is automatically sensed by the

reflective sensor and the paper position is finely adjusted for every piece. (See the Threshold Set

command for more information.)

n Mark Stock on Print Side - The black mark provided on the print side of the stock is automatically

sensed by the upper reflective sensor and the paper position is finely adjusted for every piece.

n Preprinted Die Cut Stock - The label-to-label gap is automatically sensed by the transmissive sensor

and the paper position is finely adjusted for every piece according to the value set by the threshold

setting (Consult your printer manual for further information on setting the threshold).

n Punched Hole Stock - The marginal punched holes (round holes) on the fanfold paper are

automatically sensed by the lower reflective sensor. Several round holes are automatically sensed

according to the specified length of label, and the paper position is finely adjusted for every piece.

Media

Type

n Direct Thermal - Direct Thermal type of printing (no ribbon), requires special heat sensitive media.

n Thermal Transfer - Thermal Transfer type of printing (ribbon installed).

Gap

Length

When die cut stock is used, this is the size (in .1mm) of the gap between each label.

Threshol

d Set

When Mark Stock is used, the black mark provided on the back of the stock is automatically sensed by

the reflective sensor and the paper position is finely adjusted for every piece, according to the value set

by the threshold setting. (Consult your printer manual for further information on setting the threshold.)

Ribbon

Saver

When checked, if there is a non-print area (in the feed direction) of 20 mm or more in the batch mode,

cut mode, or strip mode, ribbon saving is performed automatically.

Note: On some printers, the required non-print area is different; consult your printer manual for more

information.

Issue Settings Section

Issue

Mode

n Batch Mode - Normal printing mode; labels are continuously printed and fed out of the printer.

n Strip Mode - While in strip mode, the printer presents each label and waits for it to be removed

before continuing. The printer does not print labels if there is a label at the strip sensor.

n Applicator Mode – Similar to Strip Mode except that the printing of each subsequent label is

controlled by a pause signal from an expansion I/O device (typically an applicator) rather than the

strip sensor.

Cutter

Batch Mode must be selected and the optional cutter is required.

n After Every Job – Cutting occurs after all labels from each print request are done printing.

n After Every Label – Cutting occurs after every label that prints.

n Disabled – No cutting occurs.

n Use Cut Interval – Uses the value that is selected in the Cut Interval.

Loftware LabelManager Version 10.1.1 User's Guide

481

1 2 ... 476 477 478 479 480 481 482 483 484 485 486 ... 531 532

Comentarios a estos manuales

Sin comentarios

AMT Datasouth Fastmark M1 Guía de usuario Pagina 481

Comentarios a estos manuales