AMT Datasouth Fastmark M1 Guía de usuario descargar pdf (Pagina 452)

100

101

Supported Printers and Drivers

Label Options Section

Cutter Mode

n Cutter Off - Disables the cut mechanism

on the printer.

n Cut After Every Tag - Cuts before first tag,

cuts each tag, and cuts after last tag.

n Cut After Last Tag in Batch - Cuts before

first tag, cuts each tag, cuts after the last

tag and feeds one or two tags past the

printhead when it cuts the last tag in the

last batch.

n Cut Every Tag and after Batch – Does not

cut before the first tag in a batch, but

cuts between each tag and after the last

tag in the batch. The feed key must be

pressed to feed the last tag out far

enough to be cut.

Cut Interval

This sets the number of labels to be printed

before the stock is cut.

Forms Control Section

Horizontal Adjust

Horizontal offset (in printer dots) used during

printing.

Supply Position

Supply (label) position at beginning of print job

(-99 to 99).

Vertical Adjust

Vertical offset (in printer dots) used during

printing.

Cut Adjust

Adjusts where the tag is cut. The printer adjusts

the cut position according to the black marks

on the supply. You may need to adjust for

aperture supplies. Increase to move the cut up,

decrease to move the cut down.

Slashed Zero When checked, prints slashes through zeros.

Print Separator

When checked, prints a separator ticket.

n Single - Prints a single separator ticket (all

printers).

n Double - Prints 2 separator tickets (9835

V5.0 or 9840 V6.0 only)

Note that Double is disabled in Version 7.0.29

for the 9835, 9840, and 9850 Models.

Loftware Label Manager Version 10.1.1 User's Guide

452

1 2 ... 447 448 449 450 451 452 453 454 455 456 457 ... 531 532

Comentarios a estos manuales

Sin comentarios

AMT Datasouth Fastmark M1 Guía de usuario Pagina 452

Comentarios a estos manuales